Nibe S2125, Installer Manual, Page: 13 / 64

Installation of automatic gas
separator
The automatic gas separator and the safety valve should
always be installed as instructed below.
1. Check that all O-rings are present and that they are
undamaged. Lubricate them with soapy water or similar
to make installation easier.
Press the gas separator into place. Fit the clip. Twist the
clip to ensure that it fastens properly.
Place the bracket in position, parallel with the outer
edge. Secure the bracket with a screw. Use a socket
wrench, size 10 mm.
2. Assemble the parts of the safety valve. Ensure that the
arrow for the outlet is pointing down, as illustrated.
3. Then fit the safety valve with the associated pipes. The
safety vale must be at an angle of 45°. Fit the clip. Twist
the clip to ensure that it fastens properly.
45º
4. Install the non-return valve. Fit the clip. Twist the clip
to ensure that it fastens properly.
13 Chapter 2 | Delivery and handling NIBE S2125