Niagara 6600 Series, Installation, Operation & Maintenance Manual

Page: 40 / 44

37
Installation, Operation & Maintenance Manual M600 NIAGARA
An enable to the ENT key will exit the programming. The following message may appear for approximately
40 seconds while the program is exiting.
ChangE PaSSWORD
An enable to ENT key when EXIT is displayed will exit from the programming mode, whereas an enable to the
increment key will ask for a change of password.
An enable to the ENT key will continue with this subroutine, while an enable to the increment key will jump to the
first programming parameter (Display Mode Programming).
An enable to the ENT key will make an entry and the following message will be displayed:
An enable to the ENT key will show 00 value to password, which can be set to a desired value. After the new
password entry is complete, the following message will display:
Display will show Instantaneous Flow Rate and Flow Totalizer. An enable to the increment key after Done will
continue with the new password subroutine.
The default password (up to 80 NB) is NB size of that instrument. For instruments above 80 NB size, the default
password is 00.
STaRT/STOP OF FlOW TOTaliZER
Flow Totalizer can be stopped with a continuous enable to the increment key when the display is showing
Instantaneous Flow Rate and Flow Totalizer value. The Flow Totalizer will remain stopped until the increment key is
activated. The Flow Totalizer will restart after updating the value from the Flow Integrator, once the increment key
is released.
Please Wait ...
Copying Data ...
Change Password
?
new Password?
Done?