Niagara 6600 Series, Installation, Operation & Maintenance Manual

Page: 34 / 44

31
Installation, Operation & Maintenance Manual M600 NIAGARA
if Unit of Program is set to gPM, then Display Units can be set as gPM, gPS, gPh, CFM, CFS, or CFh. The
default value for Display Units of flow rate is GPM. An enable to the ENT key will accept the data and progamming
will jump to the next parameter in the programming queue.
Another option can be selected by enabling the increment key and accepted by an enable to the ENT key.
Another option can be selected by enabling the increment key and accepted by an enable to the ENT key.
Another option can be selected by enabling the increment key and accepted by an enable to the ENT key.
Another option can be selected by enabling the increment key and accepted by an enable to the ENT key.
Another option can be selected by enabling the increment key and accepted by an enable to the ENT key.
TOTALIZER UNITS
Next in the Display Units Mode is the Totalizer Units. This is the display of units for the built-in flow integrator. The
Unit for Display is CuM or Gals, which has to be accepted by enabling the ENT or increment keys.
If Unit for Program is CuM/hr, the following message will display:
No other option for Totalizer Units can be set for the Units for Program CuM/hr option.
If Units for Program is GPM, the following message will display:
No other option for Totalizer Units can be set for the Units for Program GPM option.
Display Unit
gPM
Display Unit
gPS
Display Unit
gPh
Display Unit
CFM
Display Unit
CFS
Display Unit
CFh
Totalizer Units
CuM
Totalizer Units
gals