14
Now move the magnet away from the Door/Window Sensor. The Console acknowledges
that it has been registered with a chime and by displaying ZONE 1 SET.
Repeat this for any other Door/Window Sensors you want to register. The display
increments to ZONE 2 SET, etc. as you install more Door Window Sensors. If you
connected a second magnetic switch to the contacts on the sensor (as shown on the next
page) move its magnet away to install the second magnetic switch as a separate zone.
If desired, you can specify what zone you want the Door Window Sensor to be registered
into. Just press the number of the zone you want on the Console’s keypad, before you
register the Door Window Sensor.
Press Clear to back out of the menu. After a short delay the display reverts to showing
HOME CONTROL on the top line and the time of day on the bottom line.
Removing Door/ Window Sensors
Follow the steps above to remove a sensor. Then when the display shows:
Press the number of the zone you desire (just as if you were going to register the Door/
Window Sensor into that zone) but instead of registering the Door/Window Sensor, press
CLEAR on the Console’s keypad. The display asks you to confirm the deletion:
Press 1 on the Console’s keypad to change the display to:
Where 13 is the zone you selected. Press 2 to take you back to the INSTALL ZONE
screen.
Press Clear to back out of the menu. You are asked to confirm, 1. YES, 2 NO. Press 1 to
return to the HOME CONTROL screen. Press 2 to take you up one level of the menu.
Installation
Armed
Power
Home
Away
Arm
1. INSTALL
ZONE
Battery
Armed
Power
Home
Away
Arm
CLEAR ZONE
1. YES 2. NO
Battery
Armed
Power
Home
Away
Arm
1. INSTALL
ZONE 13 OUT
Battery