Nexxt Solutions - Outdoor Wireless IP Camera
56
down the image frame rate).
4. Choice of switch or hub (use a switch for multiple
IP cameras rather than a hub).
Pop up appears saying ‘Fail to connect to the
device’
This prompt will only appear when using multiple
cameras. Enter the
Multi-Device Settings
page (log
in as an Administrator) to check whether the Device
settings are correct.
When one of the multiple cameras disconnects,
the icon changes color to yellow and the pop-up
prompt “
Failed to connect to the device
” is
displayed.
Can’t access the IP camera on the internet?
There could be a number of reasons:
1. ActiveX controller is not installed correctly.
2. The port IP camera being used is blocked by Fire-
wall or an anti-virus software. Use a different port
number and try again.
3. Port mapping failed. There are two ways available
for configuring port mapping:
Open the setting page of the router which the IP
camera connects with to allow the UPNP function.
Go to the IP camera’s ‘
UPnP Settings
’ to enable
UPnP, making sure the ‘
UPnP
’ configuration is suc-
cessful.
If your router has the Virtual Map function, enter
the router setting page, and add the IP camera’s IP
address and port number to the Virtual map list.
