MS-2102
6.11
Chapter 6
Setpoint Values
MESSAGE NO:
S3-14
APPLIES TO:
Control Module
DEFAULT VALUE: N/A
VALUE RANGE: N/A
DISPLAY MODE:
Advanced
RESTRICTIONS: None
This message displays the operator manual version or recorder number.
MESSAGE NO:
S3-15
APPLIES TO:
Control Module
DEFAULT VALUE: N/A
VALUE RANGE: N/A
DISPLAY MODE:
Advanced
RESTRICTIONS: None
This message displays the factory telephone number.
MESSAGE NO:
S4-01
APPLIES TO:
Control Module
DEFAULT VALUE: N/A
VALUE RANGE: N/A
DISPLAY MODE:
Advanced
RESTRICTIONS: None
This message displays the name of the sub-menu when entered.
MESSAGE NO:
S4-02
APPLIES TO:
Selected Heater
DEFAULT VALUE: disabled
VALUE RANGE: 1 to 24 hrs, disabled,
on continuously
DISPLAY MODE:
Advanced
RESTRICTIONS: None
This function manually overrides heater control for maintenance purposes. For normal
operation, set to
disable
. If you select a period of time, the heater is forced
on
for the
selected interval. If you select
on continuously
, the heater is forced on until you
select
disabled
.
MESSAGE NO:
S4-03
APPLIES TO:
Selected Control Module
DEFAULT VALUE: disabled
VALUE RANGE: 1 to 24 hrs, disabled,
on continuously
DISPLAY MODE:
Advanced
RESTRICTIONS: None
This function manually controls of the alarm output for maintenance purposes. For
normal operation, set to
disable
. If you select a period of time, the alarm output is
forced into alarm state for the selected interval. If you select
on continuously
, the
alarm output is forced into alarm state until you select
disabled
. Alarm state is
determined by ALARM CONTACTS function settting.
MESSAGE NO:
S4-04
APPLIES TO:
Control Module
DEFAULT VALUE: disabled
VALUE RANGE: 1 to 24 hrs, test now,
disabled
DISPLAY MODE:
Advanced
RESTRICTIONS: None
This function tests the ground fault monitoring function of the Control Module to
ensure proper operation. When the ground fault test is turned
on
, the Control Module
applies an ac current to the ground fault transformer and checks the measured ground
fault currents. If the Control Module does not see the test current for a heater, the GF
Test Alarm is activated and a
GF CT
message is added to the system status mes-
sages. This is a latching alarm. When the cause of the alarm has been corrected,
locate the alarm message in the Status Menu and press [RESET]. If there is no problem
detected, no alarm message is displayed.
MANUAL VERSION
1501-0019
Setpoint Tests
FOR ASSISTANCE:
(403) 735-9555
SETPOINTS
TEST
MANUAL HEATER:
disabled
MANUAL ALARM:
disabled
GF TEST
test now
