ASSEMBLY - LA26 | LAs15(A) | Ground Stack
Sub Adapter for LA26
Stacking LA26 on a LAs15(A)
1 -
Place the LAs15(A) on a flat surface and raise the four
sliding rigging arms and hold them in place with a lock pin
on each arm. Attach the ground stack sub adapter to the top
back of the LAs15(A) with two lock pins, one on each side.
2 -
Bring an LA26 cabinet and secure it to the subwoofer
starting from the front rigging arms, use one lock pin on
each side. Lay the enclosure down while holding the rear
rigging arm. The sub adapter must get into the LA26 rear
rigging slot.
3
- On the ground stack sub adapter is possible to read the
splay angle between the LA26 and the ground (blue circle),
its written “Ground Stack Angle”. Choose an angle among
the possible ground stack angles (0º, 2º, 4º, 6º) and insert a
lock pin on position 0, with “Ground Stack Pin” label, to
secure the system. When stacking on a LAs15(A), tilting
LA26 downards is not possible, stack it on a flying frame
instead.
4
- Add another LA26 fitting the front rigging hardware and
locking it with two lock pins, one on each side. At the back,
keep the top cabinet’s swivel arm up while inserting the
bottom’s swivel arm into the slot. Insert a lock pin at the
desired splay angle, leave the safety pin out. With your hand,
raise the LA26’s back up to the final position. Insert the
safety pin to lock the cabinet’s position.
19
STACKING PROCEDURES
www.next-proaudio.com
step 1
step 4
step 2-3
