ASSEMBLY - LAs15(A) | FLYING FRAME FOR
LA26
1 -
Place a 2 x LAs15(A) dolly under the lifting point.
2 -
Adjust the flying frame’s rigging shackles to meet the
best weight balance.
3 -
Unlock the dolly’s sliding lock plates (refer to page 18
step 1).
4 -
Raise the four sliding rigging arms and lock it in place
with a lock pin.
5 -
Secure the flying frame to the LAs15(A) stack inserting
the four rigging arms into the flying frame. Secure it with
four locking pins, two at the front sides and two at the back
sides.
6 -
Lift the array.
7 -
Place another 2 x LAs15(A) dolly under the array. Lower
the array until it meets the stacked one. Be sure that the
array perfectly fits in place with the stacked one.
8 -
Raise the four sliding rigging arms into the array. Insert
four lock pins, one on each arm, on the upper cabinet (the
other lock pins will be inserted on step 10).
9 -
Repeat step 3.
10 -
Lift the entire system and insert the lock pins on the
missing holes.
ATTENTION:
For a cardioid setup just rotate the LAs15(A)
by 180º. In case of active version, select preset 5 or 6.
15
RIGGING PROCEDURES
www.next-proaudio.com
step 1-4
step 5
step 6
