Installation instructions for the DIVER automatic submerged safety cover - axial - 10/24
10
Fig. 20 et 21
-
-
Push aside the two flanges so that they touch the
walls of the pool, place the blocking ring against
the drive ring of the tube then securely tighten the
screws on it.
-
-
Check that the shaft is horizontal using a spirit
level and if necessary adjust using the oblong
holes on the bearing of the flange on the side
opposite the motor.
-
-
Check the level of the shaft at each end with the
water level.
0 mm
Fig. 20
X1
X2
X1 = X2
0 mm
Fig. 21
3.2.4 Cable routing
By raceway
Fig. 22 et 23
-
-
Position the cable raceway in the beam support.
-
-
Adjust its length if necessary.
-
-
Mark the location of the fixing holes using a
marker.
-
-
Remove the raceway and drill using an ø8mm bit
to a depth of 50 mm.
-
-
Position the raceway again and fix it using M5 lag
screws.
Fig. 22
Fig. 23
