15/24 - Installation instructions for the DIVER automatic submerged safety cover - axial
15
3.4 Rear shelf fixture (option)
Fig. 41
-
-
Position the rear shelf on the rear pool wall
respecting the 60 mm measurement and the
height given on the drawing in fig. 4.
-
-
Depending on the pool width, the rear shelf may
be manufactured in several parts.
-
-
Position them so that they are level horizontally.
-
-
Mark the drill hole locations using a marker.
-
-
Remove the shelf and drill the wall to a diameter
of 12 mm and a depth of 70 mm.
Fig. 41
Fig. 42
-
-
On the stainless steel corner part, position the
TH M10 x 45 mm screws, fit the 50 mm diameter
neoprene seals behind the corner bar on each
screw.
-
-
Manually screw the brass anchors onto these
screws to slightly flare each anchor.
Fig. 42
Fig. 43
-
-
Place the corner part in position on the wall and
strike the screw heads using a mallet to insert
them in the concrete belt.
-
-
Tighten and check the solidity of the fixings.
Fig. 43
Fig. 44
-
-
Then continue assembling the roller (chapter 3)
respecting measurement A at 60 mm between the
shelf and the round beam (fig. 4).
A
Fig. 44
