Nexo NXAMP4X1, User Manual

Page: 90 / 140

NXES104 EXPANSION BOARD, REMOTE CONTROL AND ASIO DRIVER
Now, if you press the “Channel 2 Mute” on the amplifier front panel or into ESmonitor™,
the “Mute all” function will be copy back to the individual channel mute, except for the
Channel 2 that you have just pressed:
(18) Notes
In this textbox you can take some notes of your choice. The text is saved on the computer,
not on the NXAMP itself.
(19) Alias
This is the alias of the NXAMP used to display the unit in the network list, tree or group on
the left of ESmonitor™. By default the NXAMP will have an alias like this “NXAMP-XXXXXX”,
where the last six characters is the end of the MAC address of the NXES104 board fitted
into the NXAMP.
The Alias is stored on the computer. It uses the MAC address of the NXES104 to identity a
specific unit. Changing the computer or the NXES104 will disturb the alias of the units.
(20) Hardware and Firmware information
Here you check whereas the connected unit is an NXAMP4x1 or an NXAMP4x4 and what is
the firmware revision inside.
(21) ASIO Mode
This control selects the way the Remote ES100 port is used as an ASIO receiver or not.
ASIO Off
In this mode the ASIO functionality is not used, meaning that the four digital inputs of the
NXES104 board are taken from the Ethersound™ network. For example four channels of
audio are selected among the 64 channels downstream on the Ethersound™ IN port.
Channel 1
Channel 2
Channel 3
Channel 4
Mute All
PAGE 90 OF 140