GENERAL DESCRIPTION
They all are full resonant type with half bridge converter. The ZCS (Zero Current
Switching) design ensures high efficiency and low noise. Moreover, because the two
converters work in opposite phase, some noise is cancelled; this is preferable for both
sound quality and EMC (Electro magnetic compatibility).
Analog Input block
After linking the two XLRs for each channel, the analog input block has an EMC filter and a
precision input buffer that will remove the common noise on the input signal. The
maximum level allowed for the input signal is + 28 dBu (55 Volts peak to peak). The pin
out of the input XLR is given bellow.
Control block
The control block contains several sub-block that are detailed bellow.
The plain lines show the audio or sense signal (sense are voltage or current signal
measured at the output of each amplifier). The dashed lines show the digital
communication signal among several block.
You can see the audio input on the left; there are four analog inputs (from input XLR)
named Analog A, Analog B and so on… and four digital inputs (Digital A, Digital B and so
PAGE 31 OF 140
Summary of Contents for NXAMP4X1
