﹡﹡﹡
IMPORTANT NOTICE:
DO NOT return to place of purchase!!!
Please contact Customer Service hotline at 800-913-8999 for help
ASSEMBLY INSTRUCTIONS
NOTE
:
Assembly of this heater requires basic mechanical skills. Proper assembly is the
responsibility of the installer.
STEP 5
: Attach regulator
Attach 3/8 inch flare adapter on the hose
end of the regulator assembly to the flare fitting
on the intake pipe.
Secure the other end of regulator inlet fitting
onto gas tank until tight.
The 3/8 inch female IPS X 3/8 inch male flare
fitting is already attached on the intake pipe
by manufacturer.
The LP-Gas supply cylinder must be disconnected
when this appliance is not in use. Disconnect the
gas tank by turning the regulator anti-clockwise.
Page 6
STEP 4
:
Attach the reflector
Secure the 1/4
”
X 3 1/2
”
L
threaded ends
stud into emitter top.
Attach the reflector and reflector cap to
the top of emitter grid ornamental final. It
screws on to 1/4
”
X 3 1/2
”
L threaded stud
screwed into emitter top.
STEP 4
NOTICE:
EMITTER GRID COLORATION
OCCURRED DURING OUR TEST
STAGE. THIS WAS PERFORMED
TO ENSURE YOUR SAFE USAGE
STEP 5
Intake fitting
Hose Assy
Emi t t er Base
Reflector
