User's Manual
Nexel Chest Freezer
2
WARNING
1. Make sure all packaging is removed before operation.
2. Do not lean unit more than 60° while transporting, operating or servicing.
3. The freezer should be installed in an area with good ventilation, that is cool and dry and without corrosive
gases. It should not be installed close to heat sources or under direct sunlight. Leave a minimum of 4”
between the wall and all sides of the freezer.
4. Upon initial installation, operate the freezer for a minimum of 1 hour before storing food in it.
5. Before placing food into the freezer, adjust the temperature control to the lowest point (highest number) and
let it run until the temperature of inner cabinet decreases to 0° Fahrenheit. Put the food in, and after 12 hours
adjust the temperature control to the normal point.
6. Adjust the temperature inside the freezer using the thermostat. Turn the knob clockwise to lower the
temperature. The standard temperature position is “4”. The “0” position will stop operation. The “max”
position will be operating not continually as compressor won’t stop (no cycle). Turn the temperature control
to the “4” or “5” when temperature inside is stable for ice cream and similar products.
7. Never store flammable, explosive or corrosive products in the freezer, and keep the freezer away from such
materials.
8. If power is cut off, wait at least 5 minutes before turning on again to avoid damage to the compressor.
9. To save energy, the door should not be frequently opened or open for long periods of time.
10. The surface and the inside of the freezer should be dry and clean. Long term moisture with cause the freezer
rust over time.
11. Periodically wipe the inside and all surfaces of the freezer with a soft cloth with neutral soap or detergent.
Model
L"
W"
H"
243080
29.7
22
33
243081
44
25.
5
33
243082
60.4
29
32.5
Specifications Cont.
L
W
H
H
Attention: To ensure safety, the power plug must be pulled out before cleaning or servicing. All
safety precautions must be followed. Dispose of properly in accordance with Federal or local
regulations. Risk of fire or explosion due to puncture of refrigerant tubing. Follow handling
instructions carefully.
DANGER: Risk of fire or explosion. Flammable refrigerant R290/R600a used. To be repaired only by
trained service personnel. Do not use mechanical devices to defrost refrigerator. Do not puncture
refrigerant tubing.