Nexcom PEAK 7220VL2G, User Manual

Page: 49 / 63

4.12 Load Fail-Safe Defaults
This option opens a dialog box that lets you install fail-safe defaults for all appropri-
ate items in the whole setup utility.
Use this option if you have changed your system and it does not operate correctly
or does not power up.
4.13 Load Optimized Defaults
This option opens a dialog box that lets you install optimized defaults for all appropri-
ate items in the whole Setup Utility. Press the <Y> key and then <Enter> to install the
defaults. Press the <N> key and then <Enter> to not install the defaults. The optimized
defaults place demands on the system that may be greater than the performance level
of the components, such as the CPU and the memory. You can cause fatal errors or
instability if you install the optimized defaults when your hardware does not support
them. If you only want to install setup defaults for a specific option, select and display
that option, and then press the <F7> key.
4.14 Set Supervisor/User Password
The Supervisor/User Password utility sets the password. The mainboard is shipped
with the password disabled. If you want to change the password, you must first
enter the current password, then at the prompt enter your new password. The
password is case sensitive. You can use up to eight alphanumeric characters.
Press <Enter> after entering the password. At the next prompt, confirm the new
password by retyping it and pressing <Enter> again.
To disable the password, press <Enter> instead of entering a new password when
the Enter Password dialog box appears. A message appears confirming that the
password has been disabled.
If you have set supervisor and user passwords, only the supervisor password
allows you to enter the BIOS Setup Program.
Note: If you forget your password, the only way to solve this problem is to
discharge the CMOS memory by turning power off and placing a shunt (jumper
cap) on jumper JP2 to short pin 2 and pin 3 for five seconds, then putting the
shunt back to pin 1 and pin 2 of JP2.
48