Boot Up Floppy Seek
Enable this to allow the system to search for floppy drives during the POST. Disable
this item to boot faster.
Boot Up NumLock Status
Toggle between On or Off to control the state of the NumLock key when the system
boots. If On, the numeric keypad is in numeric mode. If Off, the numeric keypad is in
cursor control mode.
Gate A20 Option
Enables you to select whether the chipset or the keyboard controller should control
Gate A20. The options are:
· Normal:
A pin in the keyboard controller controls Gate A20.
· Fast:
Lets chipset control Gate A20.
Typematic Rate Setting
If set to Enabled, enables you to set the Typematic Rate and Typematic Delay.
Typematic Rate (Chars/Sec)
This setting controls the speed at which the system registers held-down key-
strokes. The choices range from 6 to 30 Chars/Sec.
Typematic Delay (Msec)
This setting controls the time between the display of the first character and suc-
cessive characters. There are four delay choices: 250ms, 500ms, 750ms and
1000ms.
Security Option
Enables you to select whether the password is required every time the system
boots or only when you enter Setup.
System:
The system will not boot and access to Setup will be denied if the
correct password is not entered at the prompt.
Setup:
The system will boot, but access to Setup will be denied if the correct
password is not entered at setup.
38
Summary of Contents for PEAK 7220VL2G
