Nexcom MAXI 6560, User Manual

Page: 49 / 76

MAXI 6560 Series User‘s Guide
BIOS Setup 4-
24
This allows your hard disk controller to use the fast block mode to transfer data to
and from your hard disk drive (HDD).
Enabled IDE controller uses block mode.
Disabled
(Default)
IDE controller uses standard mode.
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for
each of the four IDE devices that the onboard IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device.
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and
the operating environment includes a DMA driver (Windows 95 OSR2 or a
third-party IDE bus master driver). If your hard drive and y our system software both
support Ultra DMA/33, select Auto to enable BIOS support. The Choice: Auto
(Default)
, Disabled
On-Chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two
IDE channels. Select Enabled
(Default)
to activate each channel separately.
Onboard PCI SCSI Chip
This item allows you to determine whether onboard PCI SCSI chip is enabled
(Default)
or not.
USB Keyboard Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and
you have a USB keyboard. The Choice: Enabled, Disabled
(Default)
.
Init Display First
For user to select to init AGP or PCI VGA first
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has
no floppy drive, select Disabled in this field. Choices: Enabled
(Default)
, Disabled.
Onboard Uart 1/Uart 2