Nexcom MAXI 6560, User Manual

Page: 51 / 76

MAXI 6560 Series User‘s Guide
BIOS Setup 4-
26
Onboard Serial Port 4
This allows Onboard Serial Port 4 to set up disabled or 3F8H, 2F8H, 3E8H, 2E8H
Serial Port 4 Use IRQ
This allows Serial Port 4 to use IRQ 11, 10, 9, 5
Supervisor/User Password Setting
You can set either supervisor or user password, or both of then. The differences between are:
supervisor password : can enter and change the options of the setup menus.
user password : just can enter but do not have the right to change the options of the
setup menus.
When you select this function, the following message will appear at the center of the screen
to assist you in creating a password.
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password typed
now will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press <Enter>. You may also press
<Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password. A
message will confirm the password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try to
enter Setup. This prevents an unauthorized person from changing any part of your system
configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a
password every time your system is rebooted. This would prevent unauthorized use of your
computer.