Newworld NW 602F, Users Manual And Installation Handbook

Page: 13 / 27

11
panel markings. Stainless
steel can be effectively cleaned by simply using a dilute solution of water and
mild detergent and drying to a shine with clean cloth.
All parts of the oven can be cleaned with hot soapy water, take care that no
surplus water seeps into the appliance.
Remember to switch on the electricity supply before re- using the oven.
Regular cleaning is recommended. For easier cleaning, wipe away any
spillages immediately.
Shelves
Fit Trays and
between bars
as shown right
To remove the Oven Shelf
Support, push down on the
wire below the top locking
pin, pull away from the oven
wall until you can release
the top of the support from
the holes in the oven wall.
Replace in reverse
procedure.
Control Panel and Doors
void using any abrasive cleaners, including cream cleaners, on brushed
stainless steel surfaces. For best results use a liquid detergent.
The control panel, knobs and doors should only be cleaned with a soft cloth
wrung out in clean, hot soapy water. After cleaning, polish with a dry cloth.
The oven door is double glazed, the inner glass may be removed for cleaning
both inner glass and the inside face of the outer glass.
Removing the Oven Door
To aid cleaning and to make access to the oven cavity easier, the oven
door can be removed.
1.Open the door to the full extent. Unlock the locking clips on both the left
and right hinges (Fig. 7.1).
2.Gently close and align the the left and right hinge levers “A” are hooked to
part “B” of the door (Fig. 7.2).
3.Grip the sides of the door and withdraw by going forwards and upwards (Fig.
7.3).
4.Rest the door on a soft surface.