NewTek TimeWarp TW-4, User Manual, Page: 104 / 126

Page | 96
(MARK) IN
Pressing IN actually performs several related functions. First, remember that TriCaster must be in
Record mode for any instant replay marking purpose. For this reason, if you should happen to
push the IN button before enabling recording, it is enabled automatically (illuminating the
interface Record button just as if you had pressed it on the screen).
With Record active, an In Point is set for the current clip that will eventually be stored (when you
press OUT ) in the currently delegated DDR (see Section 7.2.2).
Hint: Actually, the IN button can also be thought of as a ‘reset In Point’ function. Pressing it
updates the In Point, discarding any incomplete clip (i.e., one for which an Out Point had not been
set. The partially recorded data up to that time is simply dropped (and is not added to the DDR
playlist).
ALT + IN
A different operation results when you hold down ALT (see Section 7.2.6) at the same time as you
push IN . This operation updates the In Point of the active clip in the currently
delegated DDR to the frame currently displayed.
TW-42 N
OTES
This feature is supported on TW-42 as well, but only on HD model TriCasters.
Hint: This represents a non-destructive edit of the playlist clip, equivalent to dragging the trim
handle at the left-hand end of the DDR scrub bar.
(MARK) OUT
Pushing the OUT button likewise performs a short series of several actions:

The clip currently being recorded (if any) is ended.
o
In this case, and if the Add Source to DDR Playlist is enabled in the Record
Configuration panel, the new clip is added to the end of the playlist (of the
active DDR .

Recording recommences using the current time as the In Point .
Figure 86