Newport zW Series, Quick Start Manual

Page: 14 / 16

13 | P a g e
Federal Communication Commission Interference Statement:
In order to comply with FCC radio frequencies (RF) exposure limits, dipole antennas should be
located at a minimum 7.9" (200mm) or more from the body of all persons.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference. However, there is no guarantee that
interference will not occur. If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to correct the
interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase separation between the equipment and receiver.
 Connect the equipment to an outlet on a circuit different from which the receiver is connected.
 Consult dealer or an experienced radio/TV technician.
Industry Canada Statement:
This device complies with Industry
Canada license-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement
This device has been designed to operate with antennas having a maximum gain of 2.2 dBi.
Antennas having a gain greater than 2.2 dBi are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.0
CE Statement:
The following alert sign indicates that there are restrictions on usage of the equipment in
regards to power limitations on Equivalent Isotropic Radiated Power (EIRP) levels in the
European Community.
The Following Are user Restrictions:
 Combinations of power levels and antennas resulting in a radiated power level above 10 mW -
EIRP for Direct Sequence Spectrum (DSSS) devices are considered as not compliant, and are
not allowed for use within the European Community and other countries that have adopted the
European R&TTE directive 2014/53/EU or the CEPT recommendation ERC/REC 70-03 or both.
 This device have been designed to operate with antennas having a maximum gain of 2.2 dBi.
Antennas having a gain greater than 2.2 dBi are strictly prohibited for use with this device. The
required antenna impedance is 50 ohms.