NewLine IB SERIES, User Manual

Page: 69 / 72

64
Care and Maintenance
●
Do not put or install the product near a heat source or under direct
sunlight, or in dusty or humid places, or somewhere the product may be
hit or damaged by mechanical vibration. To maximize the performance,
it needs to be put away from equipment such as grid, large metal objects
and radar stations as far as possible.
●
Do not wipe the panel with any chemical reagent. Solvents may damage
the enclosure or paint. If the panel is stained by dust, cut off the power
and then clean the panel using a dried cloth with a little of warm water.
Use a clean soft cloth to clean the LCD of the panel.
●
Do not frequently switch on and off the product, which may shorten the
product service life. After the panel is switched off, wait for three minutes
before switching it on again. If the product is not to be used for a long
period of time, please power off the product and pull out the power plug.
●
Do not maximize the brightness and contrast of the LCD for a long
period of time, which may shorten the LCD service life.
●
Do not use a hard object to write on the touch screen, which may scratch
the LCD.
The interactive panel uses the horizontal and vertical infrared matrix to
detect and locate the user's touch. The screen is surrounded by an infrared
tube (including the infrared acceptor and emitter), which forms an infrared
net covering on the screen surface. When a user touches the screen,
fingers or other opaque objects block the infrared rays that cross the touch
point, which helps the controller detect the coordinate position of the touch
point.
Dust is easily retained on the screen surface due to its long - term exposure
in the air and causes ineffective touch or inaccurate positioning. Therefore,
you need to clean the infrared tube around the screen regularly.
Maintenance Tips
Clean the Infrared Tube