Newland NLS-HR200C, User Manual

Page: 127 / 156

【
Enter Setup
】
127 **
【
Exit Setup
】
Custom Prefix
Enable/Disable Custom Prefix
If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot
exceed 10 characters. For example, if the custom prefix is “AB” and the barcode data is “123”, the Host
will receive “AB123”.
**
【
Disable Custom Prefix
】
【
Enable Custom Prefix
】
Set Custom Prefix
To set a custom prefix, scan the Set Custom Prefix barcode and then the numeric barcodes
corresponding to the hexadecimal value of a desired prefix. To save the settings, scan the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
【
Set Custom Prefix
】
Set the custom prefix to “CODE” (its hexadecimal value is 0x43/0x4F/0x44/0x45):
1. Scan the Enter Setup barcode.
2. Scan the Set Custom Prefix barcode.
3. Scan the numeric barcodes “4”,“3”,“4”,“F”,“4”,“4”,“4” and “5”. (See the “ Digit
Barcodes ” section in Appendix )
4. Scan the Save barcode. (See the “ Save/Cancel Barcodes ” section in Appendix )
5. Scan the Enable Custom Prefix barcode.
6. Scan the Exit Setup barcode.