Newland NLS-EM2045 Series, User Manual

Page: 53 / 140

Enter Setup
41 ** Exit Setup
Custom Suffix
Enable/Disable Custom Suffix
If custom suffix is enabled, you are allowed to append to the data a user-defined suffix that cannot
exceed 10 characters.
Enable Custom Suffix ** Disable Custom Suffix
Set Custom Suffix
To set this parameter, scan the Set Custom Suffix barcode, the numeric barcodes corresponding to the
hexadecimal value of a desired prefix, and the Save barcode.
Note: A custom suffix cannot exceed 10 characters.
Set Custom Suffix
Example: Set the custom suffix to
“CODE”
1. Check the hex values of
“CODE” in the
ASCII Table . (
“CODE”: 43, 4F, 44, 45)
2. Scan the Enter Setup barcode.
3. Scan the Set Custom Suffix barcode.
4. Scan the numeric barcodes
“4”, “3”, “4”, “F”, “4”, “4”, “4” and “5”. (See the
Digit Barcodes )
5. Scan the Save barcode. (See the Save/Cancel Barcodes )
6. Scan the Exit Setup barcode.