Newco Fresh Cup, Manual

Page: 10 / 22

10
“MAINTENANCE” MENU
The Fresh Cup pod brewer has a maintenance menu that consist of scrolling menu
entries that can be scanned through, backward and forward, using button A and
button B (see Fig 1). The letter to the right of the button is the buttons letter
assignment. To enter the maintenance menu, hold Button A (Open) and the Reset
key (Hot Water) down while turning on the Fresh Cup machine. Hold the keys
down until the Drain Line message appears on the display. This is the first entry of
the maintenance menu. Until the Drain Line message appears on the display the
current version will be displayed. To enter a maintenance record, press the Reset
key (see Fig 1) then use button A and button B (see Fig 1) to change the entry.
The current entries in the Main menu are as follows:
FLOWMETER ADJUST: This entry displays the value used to represent the amount
of liquid in thousandths of an ounce seen for one tick of the flow meter count.
While in this entry, pressing the A key will decrement and the B key will increment
this value. This can be used to fine-tune the amount of liquid that is dispensed.
The default value is 43.
CYCLE COUNT: This entry shows the number of brew cycles that has occurred
on this machine since the last time the count was cleared. To clear the count hold
button C down for 10 seconds while in this entry.
RESET TO FACTORY DEFAULTS: When in this option, pressing the “OPEN” key
resets the unit to its factory defaults then exits to the Maintenance Menu. To exit
to the Maintenance Menu without resetting press the “HOT WATER” key.
DRAIN LINES: In this entry the user may run the pump for 15 seconds in order to
drain any water from the lines for transportation. This function runs similarly to
the calibration function. The display will prompt “RUN PUMP” once the user has
entered this entry. To run the pump first press the ‘D’ key. The drawer will go to
the open position. At this point pressing any brew key (B, C, or D) will cause the
drawer to go to the brew position and then, once the drawer is in position, run the
pump for 15 seconds, then return the drawer to the home position. At this point
pressing ‘RESET’ will exit to the menu and pressing the ‘D’ key will start the
process again. Pressing any key while running will abort the process.
END – Exit to Main and save parameters.