63
L4000G4
www.NewLeader.com
(800) 363-1771
307074-AA-I
6� Figure 5 - Center Material Divider by
measuring from the right hand inner drop-off
point to the inner hex flat on the right hand
Spinner Hub Bolt� Repeat measurement on
opposite side� Measurements must be equal,
or no greater than 1/8” off overall�
Figure 5
7� Figure 6 - Measure on each side from Spinner
Frame back plate to forward drop-off point on
Material Divider� Both measurements must be
12-1/4” (31cm) or no greater than 1/8” (0�3cm)
off overall�
8� If adjustments are necessary, loosen the
3/8” capscrews on each side and adjust as
necessary� Once corrected, tighten hardware
to recommended torque�
12.25 "
12.25 "
Figure 6
9� Figure 7 - If equipped, Ensure the Hillside
Divider is mounted squarely and centered at
both the front and the rear� Hillside Divider
panel should be perpendicular to ground�
Ensure the rear of the panel is centered over
the center section of the Material Divider�
Figure 7
Initial Startup
