New Leader L3020G4, General Manual

Page: 30 / 111

P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
26
97372-B
Page Rev. A
INSTALLATION INSTRUCTIONS CONTINUED
FENDER INSTALLATION
Figure 5 - Fender Angle Installation
Attach fender angles to
spreader body as shown
in Figure 5. Use upper
set of holes for full or
super floatation fenders
and lower set of holes
for semi-float and truck
chassis mount fenders.
Do not tighten hardware
at this time.
NOTE: Some fenders
have angles in place of
panels shown.
Attach fenders on top of
angles/panels as shown
in Figure 6. Tighten all
hardware.
Figure 6 - Fender Installation
ELECTRIC DUMP VALVE CONTROL INSTALLATION
Figure 7 - Electric Dump Valve Control
Manual hydraulics only:
Splice wire from switch into
wire with two amp to four amp
fuse using tap connector. (See
location of tap connector in
Figure 7.) Ground ring terminal
to chain shield hardware.
Mount switch in dash or
control panel in a location that
is easily accessible while
operating vehicle.