New Holland H8060, Service Manual

Page: 14 / 51

INTRODUCTION
Operator presence system
Your machine is equipped with an operator presence system to prevent the use of some features while the operator
is not in the operator’s seat.
The operator presence system should never be disconnected or bypassed.
If the system is inoperable, the system must be repaired.
Power Take-Off (PTO)
PTO-driven machinery can cause death or serious injury. Before working on or near the PTO shaft or servicing or
clearing the driven machine, put the PTO lever in the disengage position, stop the engine, and remove the key.
Whenever a PTO is in operation, a guard must be in place to prevent death or injury to the operator or bystanders.
When doing stationary PTO work, keep clear of all moving parts and make sure appropriate guards are in place.
Reflectors and warning lights
Reflectors are located on the handrails in the areas as shown in Figure 1 .
Flashing amber warning lights must be used when operating on public roads.
86070769
1
Seat belts
Seat belts must be worn at all times.
Seat belt inspection and maintenance:
• Keep seat belts in good condition.
• Keep sharp edges and items than can cause damage away from the belts.
• Periodically check belts, buckles, retractors, tethers, slack take-up system, and mounting bolts for damage.
• Replace all parts that have damage or wear.
• Replace belts that have cuts that can make the belt weak.
• Check that bolts are tight on the seat bracket or mounting.
• If belt is attached to seat, make sure seat or seat brackets are mounted securely.
• Keep seat belts clean and dry.
• Clean belts only with soap solution and warm water.
• Do not use bleach or dye on the belts because this can make the belts weak.
To fasten the belt, pull it from the reel and push the tongue end (1) into the buckle end (2) until a "click" indicates it is
fully engaged.
47487696 17/01/2013
10