28
4. Set the speed by using the
V
or
W
KEYS
until the desired setpoint is displayed.
Holding the
V
or
W
KEYS
will cause the setting to change more rapidly.
NOTE:
The setpoint may be changed during a run without stopping the shaker by
following steps 2-4. During speed changes, an audible alarm will sound
and a visual alarm (flashing
RPM INDICATOR
) will flash until the speed
returns to within 5 rpm of the setpoint.
6.3
Checking Any Setpoint
1. Press
SELECT
until the desired indicator is illuminated.
2. Press either
V
or
W
KEYS
to enter the
SET MODE
and display the current setpoint.
CAUTION!
Holding the
V
or
W
for more than 0.5 seconds causes the speed
setpoint to change. Should this occur, resetting will be necessary.
6.4 Timed
Functions
The shaker may be programmed to automatically stop after a preset time period of 0.1
hour - 99.9 hours. There must be power to the shaker in order to set the timer. However,
a timed run can be initiated while the unit is either shaking or stopped.
To set the timer:
1. Press the
SELECT KEY
until the
HRS INDICATOR
is illuminated.
2. Press either
V
or
W
KEYS
to enter the
SET MODE
and set between 0.1 - 99.9 hours.
3. While the
SET INDICATOR
is illuminated, press the
START/STOP KEY
to program the
time (and start the run). The
HRS INDICATOR
will light and remain on for the
duration of the run. At the end of the timed run the display will read
OFF
, and the
HRS INDICATOR
will flash.
To disable the alarm (flashing
HRS INDICATOR
), press the
SELECT KEY
and change to
any other function.
To cancel the timer without stopping the shaker:
Repeat steps 1 and 2, then immediately press the
START/STOP KEY
. The
HRS
INDICATOR
will cease to flash and the display will read
OFF
.
C-24KC Benchtop Incubator Shaker
•
M1281-0050
User’s Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
