Spate cleaner TANKO-SF
44/63
Translation of the original Operating / Installation Instructions 2016/09 Rev.1
7 Maintenance
7.4.2
Tools and Tightening Torque Values
Use only proper tools which are required for performing the required work and approved for use.
Standard workshop equipment and the special tools listed are sufficient for performing mechanical
tasks on the device. The following tools are required:
–
Open-end wrench (width across flats 19 mm) or adjustable pliers wrench
–
Torque wrench SW 19 mm (measurement range minimum 25 Nm)
–
Assembly/disassembly tool for 2.4 mm locking pin or pliers with smooth parallel jaws
All the screw connections on the device are firmly tightened in the factory with a corresponding
tightening torque. This ensures that the required clamping force between the components to be joined
is also present during the time of maximum application of operating forces.
All the relevant tightening torque valued for the screw connections are listed in
section 7.5
.
Special Tools
Assembly/disassembly tool for 2.4 mm locking pin (Clipon):
Art. no. 664 MW0 102 005 0
