4
4.
Set up Instruction
On/Off
Power on
Insert batteries. (users may need a flat blade screwdriver to open);
Insert two sections of 3V CR2450 button batteries and close the battery cover.)
Turn on
Press any function key till green and red indicator flashes once.
Turn off
(Restore to factory setting)
Press and hold both function keys for 5 seconds till green indicator flashes for 20 times.
Power off
Remove Batteries.
Note:
1. Remove and insert the battery; the device memorizes previous on/off state by default.
2. On/off interval is suggested to be about 10 seconds to avoid the interference of capacitor
inductance and other energy storage components.
3. Press and hold any function key and insert batteries at the same time; it will enter
engineer testing mode.
Network Joining
Never joined the network
Turn on the device to search the network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Had joined the network
(not at factory setting)
Turn on the device to search the previous network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Fail to join the network
(when the device is on)
It is suggested to check the device verification information on the gateway or consult your
platform server provider when the device fails to join the network.
Function Key
Press and hold both keys on the
side for 5 seconds
Restore to factory setting / Turn off
The green indicator flashes for 20 times: success
The green indicator remains off: fail
Press any key on the side once
The device is in the network: green indicator flashes once and sends a report
The device is not in the network: green indicator remains off
Emergency Button
Default: Press and hold the button for 3 seconds to send an alarm data
Remark: Users can configure the button pressing time to send alarm by command
