NetUP Streamer HDMI 1x v2. User manual
11
7)
RF Frequency: Adjust it at range of 100 to 900 MHz. Set it according your regional situation or inquire your local
services.
8
) Channel 1 Level: Adjust it at range of -20~ -5dBm.
9
) Channel 1 enable: Yes/No for choosing
10-11
) Constellation: Select constellation among 16, 32, 64, 128, 256QAM
12
) Symbol rate: Modify symbol rate by pressing right/left and up/down key and to confirm by pressing Lock key. (5000-
7000Ksps)
13
) Bit Rate: User can read the current modulating bit rate and the maximum bit rate
14
) IP stream Enable.
Yes/No for choosing
15
) IP Address: The current equipment address
16
) IP Port: The current equipment IP Port
17
) IP Protocol: UDP RTP/RTSP for choosing
18
) Pkt Length: User can select from 1 to 7
19
) Null Pkt enable :On/Off for choosing
20
) RTMP enable: On/Off for choosing
21) – 24)
Please refer to
Chapter 4
for more details.
25) – 30)
Network setting, Pls referent to
Chapter 5
for more details.
31
) Save Config:
Yes/No
-to save/give up the adjustment of setting.
32
) Restore:
Yes/No
-to load/ not to load the saved configuration.
33
) Factory set:
Yes/No
-choose/not choose the factory’s default configuration.
34
) LCD Time out: A time limit that LCD will light off. Choose among 5s, 10s, 45s, 60s, 90s and 120s (seconds).
35
) Key Password: User can set a 6-digital password used to unlock the keyboard.
36
) Lock Keyboard: Choose
Yes
to lock the keyboard, then the keyboard cannot be applicable. It is required to input the
password to unlock the key board. This operation is one-off. (If forgetting your password, please use the universal code
“
005599
”.)
37
) Product ID: User can view the serial number of this device. It is read-only and unique
38
) Version: It displays the version information of this device.
Encoder Modulator
: the name of the device;
SW
: software
version number;
HW
: hardware version number. User can also press ENTER again to view the published time of this
device.
