18
Function
Command
Syntax
pass [enter]
Set password for SAS Expander enclosure
lo [enter]
Exit CLI of SAS Expander enclosure
gr {dev GroupNo[1..] {ci, cj, ck,..}
Start-Index(D) End-Index(D)}
Set zone group
sys [enter]
Show system information about enclosure
spin [delay value] [drive number]
Staggering HDD spin-up
bu [en | dis]
Operate the buzzer attribute
hspc [enter]
Report power state of each drive slot
lsd [hdd | temp | volt | curr | pwr |
con | fan | alarm]
Show status of each component on enclosure
showlogs [enter]
Show event log of SAS Expander enclosure
clearlogs [enter]
Clear event log of SAS Expander enclosure
fdl [code | mfgb] offset
Update the firmware of SAS Expander enclosure
eth [enter]
Show Ethernet port configuration
exit [enter]
exit
Close TCP/IP session
reset [enter]
Reset SAS Expander enclosure
help [enter]
Show list of commands
This section provides detailed information about NS388S enclosure’s CLI function.
All the commands please type in lower case.
The following table gives a summary of all commands to CLI function.
3.3 CLI Command
