19
CLI>
CLI>help
=====================================================================
pass
- Set Password
lo
- Logout CLI Shell
Gr
- Set the PHY Group
- Usage: gr {dev GroupNo[1..] {ci, cj, ck,..} Start-Index (D) End-Index(D)}
sys
- System Information
spin
- Drive SpinUp Control
- Usage: spin [ Delay(D)[ms] Num(D) ]
bu
- Operate the Buzzer Attribute
- Usage: bu [enldis]
hspc
- HDD Slot Power Control and Show HDD Slot Power Status
- Usage: hspc {slot [on|off]}
lsd
- List Devices Status
- Usage: Isd [ hdd | temp | volt | curr | pwr | con | fan | alarm ]
showlogs - Show the current logs
- Usage: showlogs [DisplayMode(hex, detail, default)]
Clearlogs - Clear the logs
fdl
- File DownLoad
- Usage: fdl { code | mfgb } offset
eth
- Set Ethernet IP Configuration
- Usage: eth <ipaddr(*)> <subnet(*)> <gateway(*)>
exit
- Close TCP/IP session
reset
- Resets the expander
help
- CLI Help
=====================================================================
CLI>
1. HELP Command
This command provides an on-line table of contents, providing brief descriptions
of the help sub-commands. You can use the <CLI> help to get detail information
about the CLI commands summary.
Syntax: CLI>help[Enter]
