Netopia R910, User Reference Manual

Page: 140 / 209

13-140 User’s Reference Guide
The five input filters and one output filter that make up Basic Firewall are shown in the table below.
Basic Firewall’s filters play the following roles.
Input filters 1 and 2: These block WAN-originated OpenWindows and X-Windows sessions. Ser vice origination
requests for these protocols use por ts 2000 and 6000, respectively. Since these are greater than 1023,
OpenWindows and X-Windows traffic would other wise be allowed by input filter 4. Input filters 1 and 2 must
precede input filter 4; other wise they would have no effect since filter 4 would have already passed
OpenWindows and X-Windows traffic.
Input filter 3: This filter explicitly passes all WAN-originated ICMP traffic to permit devices on the WAN to ping
devices on the LAN. Ping is an Internet ser vice that is useful for diagnostic purposes.
Input filters 4 and 5: These filters pass all TCP and UDP traffic, respectively, when the destination por t is
greater than 1023. This type of traffic generally does not allow a remote host to connect to the LAN using one
of the potentially intrusive Internet ser vices, such as Telnet, FTP, and WWW.
Output filter 1: This filter passes all outgoing traffic to make sure that no outgoing connections from the LAN
are blocked.
Setting
Input filter
1
Input filter
2
Input filter
3
Input filter
4
Input filter
5
Output
filter 1
Enabled Yes Yes Yes Yes Yes Yes
For ward No No Yes Yes Yes Yes
Source IP
address 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
Source IP
address mask 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
Dest. IP
address 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
Dest. IP
address mask 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
Protocol type TCP TCP ICMP TCP UDP 0
Source por t
comparison No
Compare No
Compare N/A No
Compare No
Compare N/A
Source por t ID 0 0 N/A 0 0 N/A
Dest. por t
comparison Equal Equal N/A Greater
Than Greater
Than N/A
Dest. por t ID 2000 6000 N/A 1023 1023 N/A