A-4 Getting Started Guide
Caution
Users should not attempt to make such connections themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum
number of terminals allowed to be connected to a telephone inter face. The termination on an inter face may
consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed 5.
Important Safety Instructions
Australian Safety Information
The following safety information is provided in conformance with Australian safety requirements:
Caution
DO NOT USE BEFORE READING THE INSTRUCTIONS: Do not connect the Ethernet por ts to a carrier or carriage
ser vice provider’s telecommunications network or facility unless: a) you have the written consent of the network
or facility manager, or b) the connection is in accordance with a connection permit or connection rules.
Connection of the Ethernet por ts may cause a hazard or damage to the telecommunication network or facility,
or persons, with consequential liability for substantial compensation.
Caution
•
The direct plug-in power supply ser ves as the main power disconnect; locate the direct plug-in power supply
near the product for easy access.
•
For use only with CSA Cer tified Class 2 power supply, rated 12VDC, 1.0A.
Telecommunication installation cautions
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
the network inter face.
•
Use caution when installing or modifying telephone lines.
•
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk
of electric shock from lightning.
•
Do not use the telephone to repor t a gas leak in the vicinity of the leak.
FCC Part 68 Information
a) This equipment complies with Par t 68 of the FCC rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.