5.
Connect the provided Ethernet cable between the WGE101 Wireless Bridge and the
gaming console or other Ethernet-enabled device.
6.
Connect the power adapter to the wireless bridge and plug the power adapter in to a
power outlet. The Power and Wireless LAN lights should light up.
7.
After you see the Wireless LAN light light up, turn on the gaming console or other
Ethernet-enabled device.
If the bridge and the Ethernet-enabled device are successfully connected, the Network
light will light up. This light flashes when there is network activity.
Note:
If your setup works with the default settings, you don’t need to configure the bridge
unless you need to change the Country/Region setting from the default setting (
U.S.A.
) or
you need to assign a unique IP address to subsequent WGE101 bridges. See page xxx for
information on configuring the bridge.
Connecting the Bridge to Multiple Devices
1.
Unpack the box and verify the contents.
2.
Identify a flat surface where you will put the wireless bridge. For best results, follow
these guidelines:
• Place it away from potential sources of interference, such as computers, monitors,
TVs, microwaves, cordless phones, or large metal surfaces.
Warning: Failure to follow these guidelines can cause intermittent or complete failure
of wireless connectivity.
• Place it in an elevated location such as a high shelf or on a wall in the center of
your wireless access area.
3.
Lift the bridge’s antenna so it is vertical.
4.
Turn off the gaming consoles or other Ethernet-enabled devices.
Gaming console or other
Ethernet-enabled device
WGE101 Wireless
Ethernet Bridge
5
Summary of Contents for WGE101
Page 1: ......
