84
NetComm Wireless Light Industrial M2M Router Plus
www.netcommwireless.com
Wake settings
Use the Wake mode drop down list to select a condition under which the router should return from the sleep state.
Only wake after specified duration and ignore ignition pin
When this mode is selected, the router wakes up after the specified time period regardless of the state of the ignition pin.
Figure 98 - Only wake after specified duration and ignore ignition pin
Enter the time in seconds to wait before returning from sleep state in the Always wake up after field. A setting of 0 means that the
router will automatically wake from sleep state immediately.
Wake triggered by ignition pin status
This mode sets the router to wake up when the signal on the ignition pin reaches the specified value.
Figure 99 - Wake when triggered by ignition pin status
Use the Sleep when ignition pin goes setting to select Low or High. By default, this is set to Low.
Advanced wake settings
The advanced wake settings screen gives you finer control over the events causing the router to wake up. In advanced wake mode,
you can configure the router to monitor for up to 2 changes in the status of the ignition pin along with how long those status
changes should last for to trigger a single wake up event. When selected, Event 1 and Event 2 must happen consecutively in that
order to satisfy each condition.
Note: If you do not wish to specify 2 events you should select to skip Event 1, in which case the router will only monitor
Event 2 to trigger a wake up.
There is also a provision to reboot the router after a specified period of time, regardless of whether the conditions of Events 1 and/or
2 are met. This can be viewed as a fall back option in the case that those Events are missed.
