YMLO-3G3WV
NetComm MyWay – 3G WiFi Router with Voice User Guide
www.netcomm.com.au
9
NETCOMM MYWAY
- 3G WiFi Router with Voice
2.6 Network and System Requirements
Before continuing with the installation of your MyWay, please confirm that you comply with the minimum system requirements below.
•
An activated 3G SIM card.
•
Computer with Windows, Macintosh, or Linux-based operating systems with a working Ethernet adapter with TCP/IP
Protocol installed.
•
A Web Browser such as Internet Explorer, Netscape Navigator, Mozilla Firefox, Opera, Safari etc.
•
Wireless Computer System Requirements
•
Computer with a working 802.11b, 802.11g or 802.11n wireless adapter.
2.7 Hardware installation
1.
Attach the supplied antenna to the port marked 3G Antenna. [This should be attached in a clockwise direction.]
2.
Insert your SIM card (until you hear a click) into the SIM slot.
3. For voice functionality, connect a standard Analogue Telephone to the port labeled Line 1 using the RJ-11 Cable provided.*
4.
If required, to activate phone jacks in your home or office connect an RJ-11 cable from the port labeled Line 2 to any
RJ-11 wall jack.
5.
Connect the power adapter to the Power socket on the back of the MyWay.
6.
Plug the power adapter into the wall socket and switch on the power.
7.
Wait approximately 60 seconds for the MyWay to power up.
Note: Please refer to your mobile service provider for activation of your voice service and information about the call charges that apply. For assistance with the operation of your
telephone handset, please refer to the documentation provided by the manufacturer of your analogue telephone.
2.8 Connecting via a cable
1.
Connect the yellow Ethernet cable provided to the port marked LAN at the back of the MyWay.
2. Connect the other end of the yellow Ethernet cable to your computer.
3.
Wait approximately 30 seconds for the connection to establish.
4. Open your Web browser, http://my.router or http://192.168.20.1 into the address bar and press enter.
5. Follow the steps to set up your MyWay.
6. After the setup process is completed you will be connected to the Internet
2.9 Connecting wirelessly
1.
Ensure WiFi is enabled on your device (computer/laptop/Smartphone).
2.
Scan for wireless networks in your area and connect to the network name that matches the Wireless network name found on the
Wireless Security Card (included in the box).
Wireless Security Card
Wireless Network Name (SSID):
xxxxxxxxxxxxxxxxxxxxxx
Wireless Security Key (WPA):
xxxxxxxxxxxxxxxxxxxxxx
3.
When prompted for your wireless security settings, enter the Wireless security key listed on your Wireless Security Card.
4.
Wait approximately 30 seconds for the connection to establish.
5. Open your Web browser, type http://my.router or http://192.168.20.1 into the address bar and press enter.
6. Follow the steps to set up your MyWay.
7. After the setup process is completed you will be connected to the Internet.
Summary of Contents for MyWay YMLO-3G8WV
