2-Port Gateway User’s Guide
78
d. From the DOS
C:\>
prompt, type:
ipconfig
and press the
Enter
key.
The command window opens.
e. The IP address displayed should be
192.168.100.xx.
4. Try rebooting the DSL/cable modem to
which the 2-Port Gateway is connected to
reset the IP address for the 2-Port Gateway.
5. Contact your network administrator or
broadband service provider.
Problems using the 2-Port Gateway
When I attempt to call into my 2-Port Gateway
from another unit via *72, I get a busy signal.
??
Make sure the account number you are
calling from is valid and has a correct PIN.
??
Make sure the account you are calling from
has sufficient funds.
??
Make sure you entered the correct number to
be dialed.
??
Make sure you entered
*72
before the
number.
??
If the port you are calling is sharing an
account number with other ports, make sure
that only the port you dialed is set to Login in
the Account Information table. See the
Net2Phone Configuration Page
in Section 4
of this guide.
Summary of Contents for 2-Port Gateway
Page 1: ...2 Port Gateway User s Guide...
Page 6: ......
Page 12: ...2 Port Gateway User s Guide 6...
