Net Safety TL-MP-KIT, Reference Manual

Page: 9 / 28

Reference Manual
MAN-0131, Revision 2 September 2012
1
Section 1: Introduction
1.1 Models covered
The multipurpose test lamp is Net Safety’s latest design in test lamps and addresses the need to
simulate a fire condition when testing any Net Safety flame detector series (UVS, UV/IRS and IR3S
Flame Detectors). The multipurpose test lamp allows simulation in classified and hazardous
locations. It consists of an electronic module and battery pack mounted inside an ATEX approved
and CSA certified enclosure.
The models available are:
•
TL-MP-KIT - Multipurpose test lamp kit, CSA approved
• TL-MP-KIT-X - Multipurpose test lamp kit, ATEX approved
1.2 Safety instructions
The test lamp generates UVC and visible radiation which can be harmful to the eyes. Proper
protective eye wear should always be worn when using the multipurpose test lamp. Unprotected
eyes are extremely sensitive to direct or indirect (reflected) radiation.
Failure to follow these installation guidelines could result in death or serious injury. Ensure that
only qualified personnel perform the installation.
Electrical shock could cause death or serious injury. Use extreme caution when making contact
with the leads and terminals.
Do not open the test lamp enclosure when in a classified area or when an explosive atmosphere
may be present.
1.3 Service support
Technical support for this product can be provided by contacting your local Emerson Process
Management/Net Safety representative or by contacting the Net Safety Technical Support
department at +1 403 219-0688 or nsm.service@emerson.com .