Net Safety TL-MP-KIT, Reference Manual

Page: 19 / 28

Reference Manual
MAN-0131, Revision 2 September 2012
11
Section 4: Maintenance
4.1 Troubleshooting
If the flame detector does not respond to the test lamp as described in this manual, verify that the
test lamp is receiving power by pointing the test lamp at a flat surface, engaging the pushbutton,
and noting a red light blinking on the flat surface. If the red light is not present, verify the charge of
the battery and replace as necessary.
Never point the test lamp at eyes. UV light is invisible and will cause damage with repeated
exposure.
If the problem remains, check all wiring to the flame detector and refer to the specific flame
detector manual for troubleshooting instructions.
If the problem persists please contact our service department to try and resolve the issue over the
phone as outlined in
1.3 . If the issue cannot be resolved over the phone, the Net Safety
representative may advise to proceed to replace either the electronic module or battery pack. For
instructions on replacing the electronic module, refer to
4.4 .
4.2 Storage
The test lamp and component parts should be stored in a location free from dust and moisture. The
device should be stored well within the range: -40°C to +55°C (-40°F to +140°F).
The test lamp uses rechargeable Nickel-Metal hydride (NiMH) batteries. When batteries are no
longer used, they should be carefully disposed of. Consult with local safety and environmental
personnel on methods of disposal.
4.3 Spare Parts/Accessories
Net Safety Part Number Description
TL-MP-EX Multipurpose test lamp - CSA approved
TL-MP-EX-X Multipurpose test lamp - ATEX approved
TLS-MP-EMOD TL-MP-EX electronics module
BAT-0009 7.2 V rechargeable NiMH battery pack with DC connector
TLS-MP-CHGR 90-265VAC 4-8 cell, NiCd, NiMH battery charger
WINDOW CLEANER 130ml spray bottle of anti-reflective cleaning solution