Net Safety TL-MP-KIT, Reference Manual

Page: 13 / 28

Reference Manual
MAN-0131, Revision 2 September 2012
5
2.3.2 Battery charger
Do not plug the charger into a DC voltage system. Disconnect battery pack from test lamp
electronics module prior to charging.
Do not use the charger in a classified area.
The battery charger should always be used indoors and should be kept away from water and dust.
To prevent overheating of the charger keep it away from temperatures in excess of 60 degrees
Celsius. When the charger is plugged into a 100 to 240Vac outlet, the charger indicator LED will be
illuminated orange within 7 seconds to indicate a connection being made to the outlet. The LED will
change to red when charging of the battery pack begins. Green with intermittent orange flashes will
indicate that charging is almost complete. Green LED indicates charging is complete. If a battery
needs replacing or the battery pack voltage is far below normal, the LED will alternate red and green
flashes to indicate error mode. When this occurs unplug the charger from the outlet then re-plug to
restart charging process. If the results are the same, replace the battery.
The charger is provided with three (3) plug adapters. Install the plug adapter to match your local AC
plug standards.
Figure 2-4: Battery Charger
Battery Charger
Mode
LED Color Output
No battery Orange 16.5 V
Initialization Orange 30mA
Fast charge Red 1.0mA
Top- off charge Green/Orange 130mA
Charge complete Green 30mA
Error Red/Green 30mA