Ness IQ-MDVR-8
41
CHANNEL: The channel of PTZ connected.
PROTOCOL: select the protocol of different PTZ, there are two protocols to switch, and the default is Pelco-D
BAUD RATE: select the different baud rate for your PTZ, there are 1200, 2400, 4800, and 9600
DATA BIT: there are 5,6,7,8 options to select, default setting is 8.
STOP BIT: there are 1and 2 to select, the default setting is 1.
VERIFY: there are None/Odd/Even/Mark/Space to select, the default setting is none.
ADDRESS: Fill the code of respective PTZ
B
）
）
）
）
EXT.COM SETUP
This interface is for external accessory connection, such as control pane, PTZ, Inertia sensor, LED screen, station
announcement and so on.
MODE: There are STANDARD and BUS MODE two options, when select standard mode, you can select each
external port for each COM, when select Bus mode, COM1 is station announcement, COM2 is amplifier board,
unchangeable, COM3 and COM4 is changeable. We can only support standard mode so far..
Remark: for the configuration details, please check the corresponding instruction for accessory.
5.3 INFORMATION
