5
S E T- U P A N D I N S TA L L A T I O N
U N PA C K I N G T H E L A M I N A TO R
Remove the cardboard box and foam. Place the unit
in a well-lit, dust-free area where the floor of the work
area is level. The laminator should not be located near
open flames or high heat, such as heat registers, stoves
or ovens. The location of the laminator should not
interfere with proper ventilation.
RO L L E R I N S TA L L A T I O N
1. Facing the front of the machine, open the lacquer
container and remove the bag containing 2 bushings.
2. Remove the scraper bar by removing the two
thumbscrews that attach it to the roller assembly (see
Fig. 2).
Figure 2: Scraper Bar and Roller Brackets
3. Remove the roller bracket thumbscrews and open
the roller brackets (see Fig 2 and Fig 3).
4. Take one of the silicone rubber rollers and slide a
bushing onto each of its rods. Next, place this silicone
rubber roller in the roller brackets with the long end of
the roller containing the plastic gear pointing to the
right.
NOTE: Make sure that the bushings are tight
against roller cores and that the bushing
shoulder is sitting inside of the roller
brackets
Figure 3: Roller Assembly with Roller
Brackets Open
5. Slide a bushing onto the other silicone rubber roller.
Place this silicone rubber roller on top of the other
silicone rubber roller that is already in the roller
brackets. Be sure that the plastic gears are lined up on
the right side.
6. The top metal roller goes in last. Slide the
aluminum gear into the motor belt on the left and then
place the top metal roller on top of the middle silicone
rubber roller. The plastic gears on the top, middle and
bottom rollers should align with each other on the
right hand side.
7. Close the roller brackets and screw in the two
thumbscrews until they are snug. Do not over tighten
or the threads may become stripped.
8. Attach the scraper bar with the remaining two
thumbscrews and tighten until they are snug.
9. Close the lacquer container.
Scraper Bar
Thumbscrews
Roller Bracket
Thumbscrews
