6
P R I N T C A TC H T R AY I N S TA L L A T I O N
Figure 4: Print Catch Tray
1.
The print catch tray can be installed on the back
of the machine by lowering the slots on the tray
onto the frame of the rear side of the lamina tor.
2.
The length of the tray can be adjusted anywhere
from 18 in. to 25 in. (46 cm to 63.5 cm) by simply
sliding it in or out.
N E B U L I Z E R I N S TA L L A T I O N
Figure 5: Inside of Nebulizer Container
1.
Remove the nebulizer from its box located in the
nebulizer container.
2.
Place the nebulizer inside of the circle in the
bottom of the nebulizer container. Make sure the
nebulizer is standing upright. Route the cable to
the outside of the container through the notch in
the container side.
3.
Plug the nebulizer into the open connector of the
cable going to the nebulizer fan.
WARNING: DO NOT plug in the unit without
making sure that the nebulizer is
standing upright and that the
humidifier container is filled with 2
in. (5 cm) of DISTILLED WATER.
Running the nebulizer not in the
upright position and without water
may damage the unit and will void
the warranty.
E L E C T R I C A L R E Q U I R E M E N T S
Connect the laminator in accordance with details as
listed on the identification label located below the rear
control panel. Refer also to the “Technical
Specifications” page for additional information.
CAUTION: Neschen-Accutech recommends that
a licensed electrician, in accordance
with electrical codes in your area,
install your main power or the
warranty will be void. Specifications
are subject to change without notice.
Neschen-Accutech recommends installation of a
Ground Fault Interrupter (GFI) circuit breaker if
operating the laminator near water or in an area of
high humidity.
The laminator must be installed close to the electrical
outlet. The plug and outlet must be readily accessible.
Plug the power cord into the grounded outlet with the
appropriate electrical service for your area. Ensure that
the outlet to be used is a three prong grounded outlet,
and that the configuration of the outlet matches the
configuration of the supplied plug.
WARNING: Any changes or modifications to the
unit supplied, without the express
written authorization and consent of
Neschen-Accutech will void the
user’s warranty, and will transfer all
health and safety obligations to the
user.
Nebulizer
Electrical
Connection
