35
4. To configure or modify the settings of the EnergyMeter, click on the corresponding "Edit" button in the
Peripherals page. A new page appears, allowing you to set all the parameters of the Analog Inputs.
A new page appears, allowing you to set all the parameters of the EnergyMeter.
ID:
The ePowerSwitch 8M+
R2
automatically creates an ID Code to clearly identify each Energy Meter. All the
ID Codes used to identify an Energy Meter start with the characters "EM" followed by a number.
Name:
In this field, enter the name you want to give to the selected Energy Meter. The name can be from 1 to 32
characters long, and can contain alphanumeric characters.
Do not use quotes or special characters in labels!
Activated
This check box must be checked to activate the device and enables to deactivate it temporarily while
keeping all its settings for a later use.
Analog Inputs
ID
The ePowerSwitch 8M+
R2
automatically creates an ID Code to clearly identify each Analog input.
•
E
followed by a number identifies each Real Energy value
•
I
followed by a number identifies each Current value
•
PW followed by A or B and a number identifies the voltage value of the 2 power inputs.
Create new rule:
Click on this button to create a new rule.
Name:
In this field enter the name you want to give to the analog input.
Do not use quotes or special characters in labels!
Unit:
In this field enter the unit of measurement you want to be display (A, kWh, V...).
Graph:
Check this box if you want a display of the analog inputs.
Period (minutes):
In this field enter the period between two measurements.
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.
