7.
For BMW vehicles only:
Please refer to the installation insert for the special guidelines for BMW
installation.
8.
For Toyota/Honda vehicles only:
In some Toyota/Lexus/Scion and Honda/Acura vehicles the CD changer port is occupied with a factory harness
(such as NAV or audio harness). The NEO package for Toyota/Lexus or Honda/Acura includes a Y shaped
vehicle cable. In order to connect the interfaces properly please follow to the scheme below.
If the car has no NAV or XM leave the female end of the Toyota or Honda (HON1) harness open.
9.
Connect Ipod Cable to the EXT2 Port and connect optional AUX or BT to the EXT1 port
10. Once the interface is connected to the radio, you will need to test the operation of the interface before re-
assembling the dash.
11. Turn your car stereo on and switch it to CD Changer mode using the Disc / Mode / CD / AUX buttons (depending
on the stereo type) on your car stereo until it shows Disc 1, Track 01 on the display. You may have to press CD
twice to access CD Changer mode.
12. Connect the iPod cable to the iPod. Turn on the iPod. You should now hear iPod music coming from the car
stereo speakers.
Once the operation of the interface is confirmed, you may continue with the installation. If you experience
difficulties with the installation, please see our
troubleshooting section.
13. Find a place where you can place the module. In many cars there is enough room inside the dashboard to place
the module.
Note: Make sure you mount the module in a place with enough room so that, when you re-mount the car stereo,
you do not break the adapter.
14. You may use the glove box or other spaces on the dash to direct the audio cables out.
15. Re-mount your car stereo, making sure its clips or screws are secure.
Adapter mounting in the trunk (for VW and BMW only)
1. Locate the trunk mounting cable in your car (usually located along the left side of the car in the back).
2. Disconnect the existing CD changer, if present.
3. Attach the matching cables
Note for BMW trunk installation:
Some BMW’s are factory wired for a cellular phone. Except for wire location, the factory cellular phone connector looks
identical to the factory 3-pin connector used for the CD changer. The CORRECT 3-pin connector for the CD changer
has
a BROWN wire (ground) in the #1 pin position.
Please make certain you use this connector.
The INCORRECT factory cellular phone connector has a BROWN wire in the center position—
DO NOT USE THIS
CONNECTOR.
