Pic. 1 The NEO CAR AUDIO Bluetooth Dongle (microphone shape and mount may vary)
Chapter 2 – General Installation
2.1 Installation location:
1. Connect the BLUBTDV9 8 pin connector to the
EXT or EXT1
port of the V9 interface. Mount
the BLUBTDV9 module away from metal structures in the dash and as close to the phone as
possible.
2. Choose a proper mounting location for the microphone either on the headliner or center
overhead console. Avoid mounting the microphone by the side windows to eliminate extra
noise. Please also avoid mounting behind visor to avoid blocking voice from reaching the
microphone. Carefully route the microphone cable down into the dash where the BLUBTDV9 is
installed. Connect the microphone to the female audio plug on the BLUBTDV9.
3. Once all connected, cycle the ignition ON-OFF-ON to initialize. Maximum range of Bluetooth
signal is approximately 20 feet.
2.2 Pairing with the Phone
You need to pair the phone with your Bluetooth receiver only once.
1. Please make sure that Bluetooth function on your phone is active or turned on and that the
phone is set to be discoverable. Refer to your phone’s user manual to learn how to turn on and
initiate the pairing feature.
2.
Turn ON vehicle and radio. BLUBTDV9 will become
discoverable by your phone for 3
minutes
.
You must pair your phone within that interval.
3. The pairing needs to be performed only once. After pairing is completed your phone will
automatically connect to BLUBTDV9 upon ignition start (whether radio on or off).
