18
Problem:
The battery operation time is significantly reduced, even
after the battery is fully charged.
Possible Cause
Corrective Action
The battery is defective,
or has reached the end of
its life (approximately
1000 charging cycles).
Replace the battery.
Problem:
The saw does not operate.
Possible Cause
Corrective Action
The battery has not been
charged sufficiently.
Charge the battery and then try to use
the drill again.
Battery Safety Feature
A battery that " fails " or seems to have a short life before it shuts
down, may simply be a battery that has gone into its SAFE mode.
A battery that has experienced an excessive current draw from a
short circuit, or a high current draw when the tool was under an
excessive load, may shut down prematurely. This is a built-in safety
feature.
If the battery contacts are not damaged , recharging the battery
for a short period ( even a few minutes ) will reset the battery`s
electronics and restore the battery voltage to the voltage level
before it shut down.
If this battery or another battery experiences the same problem
immediately upon restarting the tool, then a short circuit should be
suspected and the tool should be inspected for needed repair.
Summary of Contents for RS-18-6Li-50
Page 1: ......
